Barrel Crowning Tool 7.625/3/2023 Muzzle velocity was in the 2500 fps range. ![]() Yours may like a different recipe, so start at about 40 grains and work up in 2 tenths increments. Made a big difference in accuracy over the standard-dimension case.Ĭaveat.Keep your handloaded ammo's pressure levels close to the great, oldħX57 Mauser cartridge.The rifle liked bullets of 165 to 180 grains.Mine preferred the Hornady 165-grain boattail spire point and 41.5 grains of IMR 4064. I fire-formed the brass and sized it so that the case shoulder wouldn't set back.just barely kissed the shoulder in a FL die. You may need to face off the barrel shoulder and re-cut the chamber for safe headspace. Mount in the rear sight rails.and the rifle would shoot into an inch point five Stuck a 2X Burris LER scope in a home made Bedded the action and about an inch of the barrel forward of the action. Lightly cleaned up the burrs with a little-bitty ![]() Of the muzzle.Stuck a 60 degree countersink in the tailstock and cut about aġ6th inch into the muzzle. No taper on the barrel made it a snap to slip thru the headstock on a lathe. I did the same thing with an old 1916 dog-eared Mauser that had been rechambered to 7.62 Nato/.308 Winchester.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |